Specifications

2 PARAMETER
2-258
Classification
MACHINE
Display title
TABLE
Address Meaning Description
Cutting feed rate for pre-interpolational
acceleration/deceleration control
Program type M, E
Conditions —
L74
Unit mm/min
Setting range 1 to 999999
Set the cutting feed rate for pre-interpolational acceleration/deceleration
control.
Time constant for pre-interpolational linear
control during cutting feed rate
acceleration/deceleration
Program type M, E
Conditions —
L75
Unit msec
Setting range 1 to 5000
Set the time constant to obtain acceleration/deceleration of the cutting
feed rate for pre-interpolational linear control.
Acceleration rate for high-speed cutting
Program type M, E
Conditions —
L76
Unit %
Setting range 0 to 5000
Set the maximum cutting speed in the G61.1 mode at percentage to the
maximum cutting speed in the G64 mode.
Input of 0 is regarded as 100%.
1000 or higher percent is disposed as 1000%.
Angle for deceleration at corner before
interpolation
Program type M, E
Conditions —
L77
Unit 1°
Setting range 0 to 30
Set an angle for decelerating cutting feed rate at a corner.
Input of 0 is regarded as 5°.
Setting at an angle higher than 30° is disposed as 30°.
θ
MPL518
Return to Library