Specifications

PARAMETER 2
2-269
Classification
MACHINE
Display title
TABLE
Address Meaning Description
A-axis operation for the first T-command
after cycle start
Program type M, E
Conditions Immediate
L107
(bit 6)
Unit —
Setting range 0, 1
0: Does not operate the A-axis.
1: Returns the A-axis to its zero point.
(For AGX series)
Fixed value (0)
Program type —
Conditions —
L108
Unit —
Setting range —
Axial direction for checking for interference
at software limit 4
Bit 0: Interference axial direction (1st set)
Bit 1: Interference axial direction (2nd set)
Bit 2: Interference axial direction (3rd set)
Bit 3: Interference axial direction (4th set)
Program type M, E
Conditions After stop of movement
L109
(bit 0)
to
(bit 3)
Unit —
Setting range 0, 1
Specify the relationship between axial directions of the two axes to be
used to check for interference.
0: Same direction
1: Reverse directions
Even if the axes for the interference check are present on the same sliding
surface, the axial directions of the two axes may differ as shown below. In
this case set 1.
W-axis
Z2-axis
—
Program type M, E
Conditions Immediate
L110
(bit 0)
Unit —
Setting range 0, 1
Opposed-spindle lathe specifications
Return to Library