Specifications

PARAMETER 2
2-275
2-3-12 Machine parameter FEED VEL. (M)
Classification
MACHINE
Display title
FEED VEL.
Address Meaning Description
Rapid feed rate
Program type M, E
Conditions After stop of movement
Unit 1 mm/min (1°/min)
M1
Setting range 0 to 600000
The feed rate for moving each axis under the G00 command during
automatic operation
The feed rate for moving each axis in either the manual rapid feed mode
or the zero-point return mode
Note:
Initial zero-point return is performed at the feed rate set in parameter M2.
Feed rate for initial zero-point return
Program type M, E
Conditions After stop of movement
Unit 1 mm/min (1°/min)
M2
Setting range 0 to 600000
The feed rate for moving each axis during initial zero-point return
(reference-point return) at power on
Zero point
(reference point)
M2
N8
Feed rate
Watchdog
MPL520
Cutting feed rate limit
Program type M, E
Conditions After stop of movement
Unit 1 mm/min (1°/min)
M3
Setting range 0 to 600000
The limit of cutting feed rate during automatic operation
Even if a feed rate higher than this parameter setting is specified, the
latter governs.
Return to Library