Specifications

PARAMETER 2
2-279
Classification
MACHINE
Display title
FEED VEL.
Address Meaning Description
Axis name (for axis name changing)
Program type E
Conditions Immediate
M15
Unit —
Setting range &0 to &7F
Specify the name of the address to be used for axis name changing
(G110), by the appropriate hexadecimal number of the ASCII code.
Zero-point shift amount
Program type M, E
Conditions Immediate
M16
Unit
0.0001 mm/0.0001 deg
Setting range 0 to 99999999
The distance from the grid point to the actual zero point that exists during
zero-point return (reference point return) in the initial operation after
power-on.
Zero point
(Reference point)
M16
Watchdog
Grid point
MPL527
Axis control flag
Program type M, E
Conditions At power on
M17
Unit Bit
Setting range Binary, eight digits
Unit of output from MCP to servo amplifier
0: Millimeter
1: Inch
Direction of machine zero-point return
0: (+) direction
1: (–) direction
Error correction schema with servo on
0: To correct with motor
1: To correct with counter display
Type of axis
0: Linear
1: Rotational
Rotational direction of servo motor (Note)
(for movement in (+) direction)
0: CW
1: CCW
If axis is removed:
0: Alarm
1: No alarm
Note:
Usually, specify the rotational direction for the motor when viewed from
the front (the opposite side of the encoder). For “Spindle-Cs control”,
however, specify the rotational direction for the motor when viewed from
the rear.
7 6 5 4 3 2 1 0
Return to Library