Specifications

PARAMETER 2
2-285
Classification
MACHINE
Display title
FEED VEL.
Address Meaning Description
Cutting feed clamping speed for
superposition control
Program type M, E
Conditions After stop of axis movement
M31
Unit 1 mm/min
Setting range 0 to 600000
Set the cutting feed clamping speed for superposition control.
(Set value for the reference axis and superposition axis to be used during
superposition control.)
- Set M29 to M31 so that the following conditions are satisfied:
M29 (RA) + M31 (SA) ≤ M1 (SA)
M31 (RA) + M29 (SA) ≤ M1 (SA)
M30 (RA) + M30 (SA) ≤ M1 (SA) RA: reference axis
M31 (RA) + M31 (SA) ≤ M1 (SA) SA: superposition axis
Safety speed
(Safety supervisory mode 2)
Program type M, E
Conditions After stop of axis movement
M32
Unit 1 mm/min / 1 deg/min
Setting range 0 to 99999999
Set the safety speed to be used in safety supervisory mode 2.
If the operating speed of the axis exceeds the set value in safety
supervisory mode 2, this will cause a safety supervisory alarm and result
in an emergency stop.
Safety speed
(Safety supervisory mode 3)
Program type M, E
Conditions After stop of axis movement
M33
Unit 1 mm/min / 1 deg/min
Setting range 0 to 99999999
Set the safety speed to be used in safety supervisory mode 3.
If the operating speed of the axis exceeds the set value in safety
supervisory mode 3, this will cause a safety supervisory alarm and result
in an emergency stop. (Assign a value greater than that of parameter M32
to parameter M33.)
Safety clamping speed
(Safety supervisory mode 2)
Program type M, E
Conditions After stop of axis movement
M34
Unit 1 mm/min / 1 deg/min
Setting range 0 to 99999999
Set the safety clamping speed to be used in safety supervisory mode 2.
In safety supervisory mode 2 and while a safety clamping request is in
effect, operation decelerates to the set speed. (Assign a value smaller
than that of parameter M32 to parameter M34.)
Return to Library