Specifications

ALARM 3
3-5
3-2-2 No. 1 - No. 99, No. 1000 - No. 1099 (System/Drive error)
No. Message
Type of
error
Stopped
status
Clearing
procedure
Display
1 EMERGENCY STOP ( , , )
Cause
——
Action
——
2 EMERGENCY STOP ( , , ) E H M Red
Cause
Trouble has occurred in the hardware.
Action
Turn power off and then back on. If this does not clear the alarm status, require Mazak Technical Center or Technology
Center to replace the defective hardware or cables.
3 EMERGENCY STOP ( , , ) A H M Red
Cause
The emergency stop button on the operating panel has been pressed.
Action
Release the pressed state of the emergency stop button and reset the NC unit to its initial state.
4 —— ( , , )
Cause
——
Action
——
5 SYSTEM SOFTWARE ERROR ( , , ) E H M Red
Cause
The contents of the system software and/or custom software have been destroyed.
Action
Contact Mazak Technical Center or Technology Center.
6 REMOTE I/O ERROR ( , , ) E H M Red
Cause
——
Action
Contact Mazak Technical Center or Technology Center.
7 SRAM MALFUNCTION ( , , ) E H M Red
Cause
The S-RAM mounted on the CPU card has become abnormal.
Action
Contact Mazak Technical Center or Technology Center.
8 RAM MALFUNCTION ( , , ) E H M Red
Cause
The RAM mounted on the CPU card has become abnormal.
Action
Contact Mazak Technical Center or Technology Center.
9 ABSOLUTE POSITION MALFUNCTION (Alarm No., Axis, ) E H M Red
Cause
The absolute position detection system has lost absolute position data.
Action
Require Mazak Technical Center or Technology Center to re-set the absolute position data.
Return to Library