Specifications

2 PARAMETER
2-48
Address
(bit)
Outline
SA74 - SA80
Output in the following spindle output diagrams:
MACHINING NAVIGATION-RESULT/MACHINING NAVIGATION-PPEDICTION/Monitoring Functions
SA81 Spindle limit speed selection for spindle position control time constants — Limit speed 1
SA82 Spindle limit speed selection for spindle position control time constants — Limit speed 2
SA83 Spindle limit speed selection for spindle position control time constants — Limit speed 3
SA84 Spindle position control time constants — Time constant 1
SA85 Spindle position control time constants — Time constant 2
SA86 Spindle position control time constants — Time constant 3
SA87 Spindle speed operating time constant changeover revolutions 1
SA88 Spindle speed operating time constant changeover revolutions 2
SA89 Spindle speed operating time constant 1
SA90 Spindle speed operating time constant 2
SA91 Spindle speed operating time constant 3
SA92 Z-phase detection speed
SA93 Amount of synchronous tapping zero point shifting
SA94 Homing speed for synchronous tapping
SA95 Maximum revolutions in manual operation mode
SA96 Amount of orientation position shifting
SA97 Reduction ratio of the synchronous tapping time constant for high-speed synchronous tapping
SA98 —
SA99 Orientation time constant
SA100 -
SA113
—
SA114 Spindle speed supervisory mode 2 for safety supervision
SA115 Spindle speed supervisory mode 3 for safety supervision
SA116 Spindle safety clamping mode 2 for safety supervision
SA117 Spindle safety clamping mode 3 for safety supervision
SA118 Selecting the spindle door of the spindle whose speed is to be monitored
SA119 Deceleration judgment coefficient on safety speed clamping of the spindle to be supervised for safety
Return to Library