Specifications

2 PARAMETER
2-62
Classification
USER
Display title
POINT
Address Meaning Description
Maximum allowable spot-chamfering hole
diameter element
Program type M
Conditions Immediate
D4
Unit 0.1 mm/0.01 inch
Setting range 0 to 99
Element used to set the maximum spot-chamfering hole diameter (d)
during automatic tool development
Spot-chamfering occurs if
d ≤ D2 – D4.
If d > D2 – D4, the chamfering
cutter is developed automatically.
MPL003
Prehole through speed during inversed
spot-facing
Program type M
Conditions Immediate
D5
Unit 100 mm/min / 10 inch/min
Setting range 0 to 99
The feed rate of a tool as it is being passed through the prehole during an
inversed spot-facing cycle
Note: 0.5 mm/rev if this parameter setting is 0.
MPL004
A
t the feedrate of
D5
Drill-machining cycle setting element
Program type M
Conditions Immediate
D6
D7
Unit —
Setting range 0 to 9
Element used to automatically set drill-machining cycles during automatic
tool development
Machining cycle Conditions
Drilling cycle
DEPTH
DIA
≤
D6
High-speed deep-hole
drilling cycle
D6
<
DEPTH
DIA
≤
D7
Deep-hole drilling cycle
D7
<
DEPTH
DIA
d
D2
0
Return to Library