Specifications

2 PARAMETER
2-84
Classification
USER
Display title
LINE/FACE/3D
Address Meaning Description
Allowance of cutting start point in axial
direction (the second clearance)
Program type M
Conditions Immediate
E7
Unit 0.1 mm/0.01 inch
Setting range 0 to 99
Allowance of cutting start point in axial direction
For the line- or face-machining,
E9 is used as an axial clearance for rapid
access to the machining point from the initial point, however,
E7 is used
when the condition meets both of 1) and 2) mentioned below.
1) There is pre-machining in the same unit.
2) The parameter (
E91 to E97) that makes E7 effective is set to ON (1).
[Applicable units]
All line-/face-machining units except the face milling and angular face unit.
[Related parameters]
E91 bit 2, E92 bit 2, E93 bit 2, E94 bit 2, E95 bit 6, E96 bit 1, E97 bit 2
* Parameter that effectuates
E7 in the applicable unit.
Radial interference clearance of chamfering
cutter
Program type M
Conditions Immediate
E8
Unit 0.1 mm/0.01 inch
Setting range 0 to 999
The amount of clearance that prevents interference of the chamfering
cutter with the walls during face-machining
MPL028
Interferes.
Interference distance
E8
Allowance of axial-cutting start position
(the first clearance)
Program type M
Conditions Immediate
E9
Unit 0.1 mm/0.01 inch
Setting range 0 to 999
Element used to set the position in which the cutting feed in axial direction
is to be started after the line- or face-machining tool has been moved from
the initial point toward the workpiece at a rapid feed rate
Example:
MPL029
Initial point
SRV-Z
E9
Depth-of-cut-R automatic setting element
(Face milling, End milling-top, End milling-
step)
Program type M
Conditions Immediate
E10
Unit 10%
Setting range 0 to 9
Element used to automatically set the radial depth-of-cut (
WID-R) of the
tool sequence in
FCE MILL, TOP EMIL or STEP unit
WID-R
=
NOM-
φ
×
E10
10
Example:
SNo. TOOL NOM-
φ
No. APRCH-X APRCH-Y TYPE ZFD DEP-Z WID-R
R1 FCE MILL 100A ? ? XBI
"
1.
19.
↑
NOM-
φ
×
E10
10
Return to Library