Owner`s manual

27
7. To raise or lower the bit, adjust the graduated depth-adjusting ring on the router base. It indicates the exact
distance of the bit below the sub-base.
8. Start the motor (see “Starting and Stopping the Motor”), and allow it to reach full speed before beginning the
cut.
9. When the motor has reached full speed, slowly and smoothly pull the carriage so the blade runs through the
work piece. Keep one hand on the handle at all times. Be careful not to force the bit through the work piece,
to avoid binding.
10. Once the cut is complete, turn off the motor and wait for the bit to come to a full stop. Move the work piece
away from the bit. Return the carriage to the top of the guides, and lock the carriage lock.
Switching Between a Saw and Router (Model SR5, SR5U)
To remove the saw and install the router on the Models SR5 or SR5U:
WARNING: Always disconnect the power before interchanging the saw and router.
1. Disconnect the saw power cord. Remove the saw assembly by removing the two thumbscrews at the top of
the turntable.
2. lnsert the router assembly into the carriage in the same manner and attach it with the two thumbscrews.
3. Attach the adjustable clamp(s) on the frame as shown in Figure 29: insert the L-screw down through the hole
in the clamp-mounting bracket and secure with the red knob.
4. If routing on the rollers be sure to use your lower clamps to secure the material.
To remove the router and install the saw:
1. Disconnect the router power cord. Remove the router assembly by removing the two thumbscrews at the top
of the turntable.
2. Insert the saw assembly into the carriage in the same manner and attach it with the two thumbscrews.
3. Remove the adjustable clamp(s) from the frame.
Figure 29: Adjustable Clamp (Routing)
Removing the Motor
Models C4, C5, H4, H5, and H6
To remove the motor from the turntable (see Figure 30):
1. Disconnect and lock off the power supply.
2. Remove the blade guard (Not shown below).
3. Remove the saw blade (Not shown below).
4. Remove the nuts from the two lower hanger bolts (6 and 10).
5. Support the motor by hand, and remove the upper hanger bolt (10) and spacer (9).