Owner`s manual

28
To reattach the motor, reverse the above procedure. Use your set screw (11) to reset the motor.
Figure 30: Removing the Motor (Models C4, C5. H4, H5, H6)
Models 6400 and 6800
1. Disconnect and lock off the power supply.
2. Remove the blade guard.
3. Remove the saw blade.
4. Support the motor by hand, and remove the two mounting bolts.
To reattach the motor, reverse the above procedure.
Figure 31: Removing the Motor (Models 6400, 6800)
Models 7400 and 7400XL
1. Disconnect and lock off the power supply.
2. Remove the belt guard.
3. Slip the belt off the pulley.
4. Support the motor by hand, and remove the four mounting bolts.
To reattach the motor, reverse the above procedure.
Routers
1. Disconnect and lock off the power supply.
Upper Screw
Lower Screw