Owner`s manual

38
Operation
1. Position the stop block at the desired cut length, as shown by the Quick Stop measuring tape, and secure the
block with the lock knob.
2. Raise the carriage to the top of the guides.
3. Slide the work piece behind the carriage, and hold it firmly against the stop block. Never reach behind the
carriage!
4. Cut the work piece with a smooth, continuous down stroke of the carriage.
Midway Fence
The Midway Fence Accessory is a removable horizontal work piece support that mounts halfway up the tool frame.
It allows narrow work pieces to be worked at waist height. The fence consists of left and right fixed brackets that
mount to the frame, and removable supports for each side. The accessory contains the components shown in
Figure 44.
The Midway Fence is optional on the Models C4, C5, H-Series, 6400, 6800, and 3400. It is standard on the
Models SR5, SR5U, 7400, and 7400XL, and is not available for the Model TR-2.
Installation
NOTE: All hex nuts furnished with this accessory are lock nuts. During pre-assembly, do not completely tighten
these nuts.
1. Lay out the parts shown in Figure 44 on a horizontal surface (table or bench) for pre-assembly. Note that one
end of each fence extrusion is cut at a 45° angle. The units should be pre-assembled so that these beveled
ends will fit against the center of the tool frame at final assembly.
Figure 44: Pre-assembly of Midway Fence
2. Set the complete right-hand fence assembly onto the tool frame as shown in Figure 45.