WARNING CAUTION Power Supply Ensure the source voltage matches the voltage of the power supply before turning The symbol is used io indicate that ON the apparatus. some hazardous live terminals are involved within this apparatus, even Unplug this apparatus during lightning under the normal operating conditions. Storms or when unused for long periods of time.
» Protective Grounding Before turning the product ON, make sure that it is connected to Ground. This is to prevent the risk of electric shock. Never cut internal or external Ground wires. Likewise, never remove Ground wiring from the Protective Ground Terminal. Never cut off the internal or external protective grounding wire or disconnect the wiring of protective grounding terminal. The apparatus shall be connected to a mains socket outlet with a protective earthing connection.
FEATURES: 1. Output: RMS 60W 2. 3 MIC (XLR) INPUTS; MIC/LINE/PHANTOM exchanges SW 3.1 AUX {RCA} INPUT 4. Two TONE (BASS/TREBLE) Adjustment 5. 4 input volume adjustments; 1 MASTER 6. PRE out, AMP input, LINE out. 7. Recording select function. 8. impedance output is4 (2; constant voltage outputs 28V, 70V, 100V 8.
CONTROL ELEMENTS: 1. FRONT PANEL a POWER AMPLIFIER (1) POWER SWITCH The main power can be switched on or off. (2) TREBLE Use the knob to control the high frequency at the range of +10dB. Turn clockwise to boost and counterclockwise to attenuate the treble response. Tone is flat at center. (3) BASS Use the knob to control the low frequency at the range of £10dB. Turn clockwise to boost and counterclockwise to attenuate the bass response. Tone is flat at center.
INPUT it is used for DC power supply for 24V. You should pay attention to the polarity. {9) OUTPUT TERMINALS Connections for low impedance 4 Q speakers; connections for constant voltage 25V, 70V or 100V speakers. {10} AMP INURE OUT Jacks AMP IN and PRE OUT to insert an audio unit for signal processing. {11} MUSIC ON HOLD VOL It is used to monitor volume of black ground music and AUX. (12) MUSIC ON HOLD OUTPUT it is connected to monitor the signal of AUX input.
{18} AC JACK This connector is meant for connection of the supplied main cord. Do not insert the power cord into this unit until voltage has been correctly set. {17) POWER SELECT SWITCH There are two voltages to choose: 110-120V~ and 220-240V~ (18) LINE QUT iris connected to recorder and used 1o pass on the mixed signal. {19) AUX IN iris used for AUX input. {20} INPUT-3 They are used for both balanced and unbalanced inputs.
TECHNICAL SPECIFICATIONS AMS output AC:60W RMS output; DC: 47W RMS output Frequency response | THD.
Cassette recorder ea Microphone stand 0,0 OQ Mains MN, Spenser Horn speaker Sound column Equalizer [“==aa Power amplifier ee Fo I] fun Speaker Designate