User Manual

9
EN
TEA TYPE Green White Oolong Herbal Black
Preset Brew Temp
80°C 85°C 90°C 95°C 100°C
Steep
Time*
(mins)
Mild
2 2 2 3 1
Medium*
3 3 3 4 2
Strong
4 4 4 5 3
* Preset steep time is based on medium
strength, but you can adjust depending
on your taste.
NOTE
This product is not calibrated for commercial
or scientic use. Temperatures may vary
+/- 3°C, which is within range for optimal
brewing for each tea variety.
3. Start heating by pressing START/CANCEL
button. The Sage Smart Tea Infuser
™
will
start heating.
4. Once the selected brew temperature is
reached it will beep 3 times. Open the tea
basket lid by pressing the detachment
button and use a tea spoon
(approximately 5g) to ll the basket
with tea leaves. As a general guide, use
1 teaspoon of tea leaves per cup / 250ml
of water, however this will depend on the
instructions on tea packaging and your
personal preference. Re-place the tea
basket lid.
Water to tea scoop ratio
500mL 2 teaspoons
750mL 3 teaspoons
1000mL 4 teaspoons
1250mL 5 teaspoons
1500mL 6 teaspoons
1700mL 7 teaspoons
5. Start steeping by pressing the
START TIMER button. The timer is set
based on medium strength by default,
but you can change this by pressing
STEEP TIME button.
NOTE
Temperature and time can be changed during
heating or steeping cycle.
6. Once brewing cycle is complete, the Sage
Smart Tea Infuser
™
will beep 3 times. Lift
the inner lid along with tea basket, and
detach the tea basket. Then close the lid.
Your tea is ready now. The Sage Smart
Tea Infuser
™
will keep the tea warm until
you are ready to drink.
KEEP WARM
If selected prior to heating, Keep Warm will
last for 30 minutes after tea is brewed. When
the glass jug is removed from the power base,
the Keep Warm function will cancel.
To reactivate for another 30 minutes place the
glass jug with the remaining tea back on the
power base and press KEEP WARM, the light
will illuminate when this is selected.
BOILING WATER
Remove the tea basket and ll the glass jug
with water. Close the jug with the lid. Select
the desired temperature by pressing TEMP/
KEEP WARM button, and then turn o time
indicator by pressing STEEP TIME button.
Press START/CANCEL button to start. When
nished, it will beep 3 times.
CHANGING BEEP VOLUME
Press and hold STEEP TIME button and
TEMP/KEEP WARM button together for
2 seconds to enter volume adjustment mode.
Press STEEP TIME button to choose among
OFF (mute), 3 (default), and 5 (louder).
To save and exit, press the two buttons
together or wait for 7 seconds.