User Manual

17
4. The Cooling cycle (green light) is the last
cycle before completion. The Cooling
mode lasts under 30 minutes.
5. The Change Filter light (red) will illuminate
when it is time to replace the lters.
CHANGE
FILTER
COOLING
GRINDING
DRYING
NOTE
Typical processing time takes an average of
4 - 6 hours. Cycle time will vary depending
on the types of food being processed and
the total moisture content. Total maximum
processing time is 8 hours. The cooling
phase takes up to an additional 30 minutes.

Your EcoFilters should be replaced regularly
or as indicated to ensure an odourless cycle.
If the FoodCycler is used regularly, the lters
will need to be changed every 3-4 months
(500 Cycle Hours).
At the end of this period, the Change Filter
light will illuminate red indicating that the
lters need to be replaced.
• Remove all packaging from the EcoFilters
and Filter Air Guides before rst use.
Remove all packaging from replacement
lters before tting into the FoodCycler.
Follow the steps described below.
NOTE
Always change both lters at the same time.
IMPORTANT
The lters are not washable. Do not immerse
any part of the lters in water as it will cause
damage.
To replace the EcoFilters:
1. Open the back panel of the FoodCycler
by pressing down on the plastic tab at the
top of the panel (with the arrow), then pull
outwards to release. Remove the two lter
air guides sitting on top of the lters by
tilting slightly towards you, then lift them up
and out of the FoodCycler. Do not discard
the lter air guides.
2. Keeping the used lters straight, twist
each of them counter-clockwise to
remove from the lter cavities. Remove
one at a time.