User's Manual

www.tuv.com
Test Report No.: 14014172 001 Appendix 4 page 19 of 33
(Page 4)
Insert the Sagem charger plug into the charger adaptor and then Charger Adaptor plug into the Sagem BT H4
Headset for Charging. The light on the Sagem BT H4 Headset (status indicator) will stay red during charging.
IMPORTANT: Charging indication will be delayed for a few seconds if the headset has not been used for
a long time or the battery is drained.
Normal Charging Time
It takes about three hours to fully charge the battery. When the battery is fully charged, the status indicator will
turn blue and remain on. Unplug the mains charger from the AC wall outlet and the charger plug from the
headset. Press and hold the MFB (refer to Figure 1) for two seconds to turn on the headset. Please refer to
“Turning Your Headset On and Off” on the next page for further details.
Important: The headset will turn off and no operation while in charging mode. For details, please refer to
"Charging your headset" section.
Talk and Standby Time
A fully charged battery can offer up to 12 hours of talk time and up to 180 hours of standby time. When there are
no calls the headset should remain turned on in standby mode.
Battery Low Indication
When the battery has become low when the headset is on, the status indicator will flash red and the headset will
emit a beep* every minute. Please follow the instructions described above to recharge the battery.
*If you are pairing your headset and your mobile phone in a noisy environment, we advise you to put on the
earphone first so that the beep will be more audible.