Operation Manual

23
You can carry out the following operations over a remote telephone:
8. PRIVILEGED ACCESS
PRIVILEGED ACCESS CODE
If you do not want to be disturbed by anyone except privileged access callers (with a special access code), set the
unit to TAD receive mode and enter a privileged access code:
Press MENU, 4, 7 and START.
Enter an access code other than 0000 and press START to confirm.
Note: you must activate the privileged access facility using MENU 48 (setting: WITH).
INCOMING CALLS
Only those callers to whom you have given this code will be able to reach you. They must:
Dial your number.
Wait for your terminal to answer the call.
Press the key, then enter the 4-digit privileged access code.
Notes: If you do not answer the call, the caller will be prompted to leave a message on your TAD.
The "remote message retrieval" and "privileged access" codes must be different. To disable the
privileged access facility, simply set the code to 0000.
Whilst listening:
• pause or resume message listening by pressing .
• go on to next message, by pressing .
• go to the beginning of the message, by pressing .
• go back to the previous message, by pressing twice.
After listening:
• delete received messages, by pressing and .
• record your announcement, by pressing and and
stop the recording of your announcement, by pressing any
key,
• listen to your announcement, by pressing .
• switch on your answering machine, by pressing .
• switch off your answering machine, by pressing .
• resume message listening, by pressing .
Liasse 23228000-2 A (T).book Page 23 Jeudi, 5. août 1999 9:26 09