Operation Manual

24
BASE SETTINGS
Select CHANGE CODE using  or . Press
OK.
Enter the old base code using the keypad
(default is 0000). Press OK.
Enter the new base code using the keypad. It
must be composed of 4 digits miminum up to
8 digits maximum. Press OK.
Confirm by entering the new base code
again. Press OK.
To exit the menu, press the red key .
Re-initialise the base
When you re-initialise your base, all the base
parameters are reset to their initial values
(factory settings).
On the navigator key , press  or  until
the BASE SET screen is displayed, press
OK to confirm.
Select REINIT BASE using  or . Press
OK.
Enter the base code. Press OK.
To exit the menu, press the red key .
Note carefully the new base code on
the back cover, you will need it to
modify some parameters.
When you re-initialise the base, the
base code becomes 0000 again and
the voice box number must be re-
programmed. “Modifying the voice
box number”, page 21.
LU 252117222C_D20V_EN.book Page 24 Mercredi, 24. août 2005 11:46 11