Operation Manual
89
SETTINGS
A screen prompts you to confirm the setting of the base to the registration
mode. Press Yes to enter the registration mode. The indicator light on
your base starts to quickly blink green.
You base will remain in registration mode for about 1 minute.
Resetting the base
When you reset your base, all the base parameters are reset to their initial
values (factory settings).
On the navigator key , press or until the Settings screen is
displayed, press OK to confirm.
Select Adv. Settings using or . Press Confirm .
Select Base Settings using or . Press Confirm .
Select Reset Base using or . Press Confirm .
A confirmation screen will prompt you to confirm your request:
• To reset the base, press Yes .
• If you do not wish to reset the base, press No .
Enter the base code using the keypad. Press Confirm .
To exit the menu, press the red key .
You can also use the base buttons to put the base in registration
mode: Press on the button on the base for a few seconds.
When resetting the base, the base code becomes 0000 again.
LU D85C UK.book Page 89 Jeudi, 16. décembre 2004 5:30 17