Operation Manual

ManualsBrandsSagem ManualsAudioHM 40

RECORDING A RADIO PROGRAMME

1. Select the Record > Record menu, and confirm.

2. Select the required Station and confirm.

3. Define and confirm the start time of the recording:

 turn the knob to reach the desired time,

 press the knob to confirm the time displayed.

Thus, first define the hours, then the minutes.

4. Define the Recording duration (from 0 to 90 minutes maximum).

When the recording starts, the screen shows the progress and the start and end time of the

recording.

LISTENING TO THE RECORDING OF A RADIO PROGRAMME

Enter the Record > Playback menu.

The recorded programme is broadcast and the screen displays its length.

DELETING THE RECORDING OF A RADIO PROGRAMME

In the Record > Delete menu, confirm the deletion.

MAINTENANCE

Radio

Clean your radio using a soft, lint-free cloth.

Battery (model HM40),

After a prolonged period without use (several months), during the charging phase, the device will

not start immediately. Some time may elaspe before the battery is once again operational.

TROUBLESHOOTING

When you record a new programme, the previous recording is deleted.

Some chemical products may damage the plastic. Do not use spray products, certain

special cleaning products, corrosive products, solvents, alcohols or detergents, etc.

Problem Causes Solutions

You cannot switch on the radio Mains plug fault

Check that the radio's power

plug is connected and that the

mains plug is powered.

Impossible to recharge the

battery (only HM40)

Battery or charger damaged

Check the battery and the

charger.

Charger not properly

connected to the radio or the

mains

Check the charger

connections.

Reduction in standby

autonomy

Battery charge capacity too

low

Replace the battery.

Too far from the network

emitter, the radio is constantly

looking for the signal

Searching for the network

uses up battery power. Find a

place where the signal is

stronger or temporarily switch

off your radio.

Bad quality radio reception Signal too weak

Find a place where the signal

is stronger.

Unfold the aerial fully.

LU_HL40_HM40_EN.book Page 11 Lundi, 9. mai 2011 9:17 09