Operation Manual

5-12
Operation
Date en cours : 11 juin 2001
\\Sct31nt3\doc 31nt3 mac\SAGEM FM\DOC EN COURS\MFC 23260972-6_38xx Sagem GB\Utilisation.fm
Setting parameters for the scanners .
Each of the two scanners may be set separately.
•
RESOLUTION to set the photocopy resolution,
•
ZOOM and ORIGIN settings to reduce or magnify any portion of a document by choosing the
origin and value of the zoom to apply to that portion.
•
CONTRAST to choose the photocopy contrast.
•
SATURATION is used to set the colour stauration level.
•
RGB (Red, Green, Blue). Your machine lets you perform individual settings for the Red,
Green or Blue colours of any image placed in your original document.
•
BRIGHTNESS is used to make your original document lighter or darker.
•
L/R MARGINS to shift the margins of your original document to the left or to the right.
Setting parameters for the printer.
•
BRIGHTNESS is used to choose the copy quality on the printer.
•
PAPER is used to tell your machine what type of paper you use by default.
•
TRAY is used to tell your machine which paper tray shoud be used by default.
•
L/R MARGINS to shift the margins of your document to the left or to the right.
Caution - All the settings performed through this menu will become the machine's default
settings.
To access to the settings
M
ENU : 87 - A DVANCED FUNCTIONS / S CAN . AND P RINT .
+ Select the scanner (CIS SCANNER for the sheet-feed scanner, CCD SCANNER for the flat-bed
scanner) or the
PRINTER to be set and pres Ok to confirm.
+ use keys 5 or 6 of the navigator to scroll the described hereafter settings you want to
modify.
6FDQQHUVHWWLQJV
5HVROXWLRQ
+
Set the desired resolution FAST, QUALITY or PHOTO with keys 3 or 4.
+ Validate your setting by pressing key OK.
=RRPDQG2ULJLQ
Your fax offers you to reduce or magnify a determined part of a document by 25 to 400 %.
+ Enter the desired zoom value with the numeric keypad (ZOOMING).
+ Validate your setting by pressing key OK.
If you wish, you can change the origin of the flat-bed scanner (by default, this is the front left angle
of the scanner window marked with two arrows)
By entering new values of X and Y given in mm (X < 210 and Y < 297), you will move the scanned
zone as shown on the figure below
LIASSE 23260972-6.book Page 12 Lundi, 11. juin 2001 5:31 17