Operation Manual

Setting your machine
3-15
Operation Setting your
machine
Getting startedDirectoryMaintenanceSafety ContentsInstallation
PRINT FUNCTION SETTINGS
The printer can be connected to the local network as it has its own IP address.
Updating network settings
The print console allows you to:
• Turn TCP/IP, NetWare and EtherTalk on or off.
• Turn DHCP on or off.
• Enter the IP address, the subnet mask address and the default gateway address.
To check or change the network card settings:
 Press the MENU key.
 Repeatedly press the or keys until INTERFACE appears.
One of the interface names below appears, showing that it is the current interface.
 Press ENTER, a blinking "?" appears.
 Repeatedly press the keys or until OPTIONAL appears.
Press
ENTER.
 Press the > key.
 This example shows how to switch the TCP/IP protocol on to connect the terminal to the
network. You can switch Netware or EtherTalk on in the same way.
If TCP/IP is OFF. Press
ENTER, a blinking "?" appears. Select ON using the or keys.
Press ENTER again.
Automatically configuring IP settings
You can make these settings when the TCP/IP protocol is on. We recommend that you manually
configure your terminal. However, local network settings can be automatically configured if you
have a DHCP or BOOTP server on your local network which can dynamically distribute
addresses to peripherals on the LAN.
To automatically configure network local settings:
MENU - - INTERFACE > - - TCP/IP > DHCP
 Press ENTER, a blinking "?" appears.
 Select ON using the or , then press ENTER.
•
PARALLEL (default setting)
•USB
• OPTIONAL (when the network card is installed)