User`s manual

10
USING THE MACHINE AS A NETWORK PRINTER
18
When "The installation of the SAGEM
software is complete" appears, click
the "OK" button.
19
Begin the installation of the Printer
Status Monitor (if "Printer Status
Monitor" was selected in Step 7).
Follow the on-screen instructions.
Click the "Finish" button when the
message informs you that setup is
successful.
20
When the "Finish" screen appears,
click the "Close" button.
When "After Windows system restarts,
connect the interface cable to the PC"
appears, click the "OK" button.
If you are using Windows NT 4.0, this
completes the installation procedure.
Check the items indicated at the end of page 11
and install any components or configure any
settings that are necessary.
If you are using Windows 2000/XP, configure
the port setting next.
21
Click the "start" button, click "Control
Panel", click "Printers and Other
Hardware", and then click "Printers and
Faxes".
In Windows NT 4.0/2000, click the "Start" button,
select "Settings", and then click "Printers".
22
Click the "SAGEM MF-XXXX" printer
driver icon and select "Properties"
from the "File" menu.
23
Click the "Ports" tab and click the "Add
Port" button.
24
Click "Standard TCP/IP Port" and click
the "New Port" button.
"Add Standard TCP/IP Printer Port
Wizard" starts.
25
Click the "Next" button.
26
Enter the IP address in "Printer Name
or IP Address:" and then click the
"Next" button.
Enter the IP address of the machine that
you previously wrote down. The IP
address [10.36.128.226] is shown as an
example in the above window.
After the installation, a message
prompting you to restart your computer
may appear. In this case, click the
"Yes" button to restart your computer.
Note
"IP_(entered IP address)" is
automatically entered in "Port Name:".
You can change the name if desired.
Note