User`s manual

18
USING THE MACHINE WITH A PARALLEL OR USB CONNECTION
9
Check the packages on the screen, and
then click the "Start" button.
The software packages to be installed will
be displayed on the screen. If an incorrect
package is displayed, click the "Back"
button and select the correct packages.
10
Begin installation of the printer driver (if
"Printer Driver" was selected in Step 8).
Follow the on-screen instructions.
11
When you are asked how the printer is
connected, select "Connected to this
computer" and click the "Next" button.
12
When the display font installation
window appears, select whether or not
you wish to install the display font and
click the "Next" button.
To install the display font, select the "PCL
Display Font" checkbox.
13
Follow the on-screen instructions.
When "The installation of the SAGEM software
is complete" appears, click the "OK" button.
14
When the "Finish" screen appears,
click the "Close" button.
When "After Windows system restarts,
connect the interface cable to the PC"
appears, click the "OK" button.
15
Connect the interface cable to the
machine and your computer (p.25).
• If you are using a USB cable, make
sure the machine's power is turned on
and then connect the cable.
• If you are using a parallel cable, turn
off the power of the machine and your
computer, connect the cable, turn on the
power of the machine, and then turn on
your computer.
Windows will detect the machine and the
Plug and Play screen will appear.
If the following screen appears while
the files are being copied (the
message may appear more than once),
click the "Continue Anyway" button.
After the installation, a message
prompting you to restart your computer
may appear. In this case, click the
"Yes" button to restart your computer.
Caution
Note