User`s manual

20
USING THE MACHINE WITH A PARALLEL OR USB CONNECTION
Installation in Windows 98/Me/2000 (USB cable)
1
The USB cable must not be connected
to the machine. Make sure that the cable
is not connected before proceeding.
If the cable is connected, a Plug and Play
window will appear. If this happens, click
the "Cancel" button to close the window
and disconnect the cable.
2
Insert the CD-ROM into your computer's
CD-ROM drive.
3
Double-click "My Computer" ( ), and
then double-click the CD-ROM icon ( ).
4
Double-click the "setup" icon ( ).
5
The License Agreement window will
appear. Make sure that you understand
the contents of the license agreement,
and then click the "Yes" button.
6
Read the message in the "Welcome"
window and then click the "Next" button.
7
Click the "Drivers/Status Monitor" button.
8
Select the checkboxes of the software
packages to be installed and then click
the "Next" button.
Click the "Display README" button to show
information on packages that are selected.
9
Check the packages on the screen, and
then click the "Start" button.
The software packages to be installed will
be displayed on the screen. If an incorrect
package is displayed, click the "Back"
button and select the correct packages.
10
Begin installation of the printer driver (if
"Printer Driver" was selected in Step 8).
Follow the on-screen instructions.
11
When you are asked how the printer is
connected, select "Connected to this
computer" and click the "Next" button.
The cable will be connected in step 16.
If the language selection screen
appears after you double click the
"setup" icon, select the language that
you wish to use and click the "Next"
button. (Normally the correct language
is selected automatically.)
Note
Note
If the machine is connected to your
computer with a USB cable or parallel
cable, the Printer Status Monitor
cannot be used.
Note