User`s manual

24
USING THE MACHINE WITH A PARALLEL OR USB CONNECTION
16
Select whether or not you wish the
printer to be your default printer and
click the "Next" button.
If you are installing multiple printer drivers,
the following window will appear. Select
the printer that you wish to use as your
default printer.
If you do not wish to use any of the
printers as the default printer, click the
"Set Default Printer" checkbox to remove
the checkmark.
17
When the window for entering a printer
name appears, click the "Next" button.
If you wish to change the printer name,
enter the desired name.
18
When the display font installation
window appears, select whether or not
you wish to install the display font and
click the "Next" button.
To install the display font, select the "PCL
Display Font" checkbox.
19
Follow the on-screen instructions.
20
When "The installation of the SAGEM
software is complete" appears, click
the "OK" button.
21
When the "Finish" screen appears,
click the "Close" button.
When "After Windows system restarts,
connect the interface cable to the PC"
appears, click the "OK" button.
22
Turn off the power of the machine and
your computer, and connect the
machine to your computer with the
parallel cable. (p.25)
After connecting the machine to your
computer, turn on the power of the
machine and then start up your computer.
This completes the installation of the
software.
• If you installed the printer driver, configure the
printer driver settings as explained in
"CONFIGURING THE PRINTER DRIVER"
(p.30).
• If you installed the PS printer driver, the PS
display font can be installed from the
"SG-PEK" CD-ROM that accompanied the
PS3 expansion kit. (p.28)
After the installation, a message
prompting you to restart your
computer may appear. In this case,
click the "Yes" button to restart your
computer.
Note