Operation Manual

42
Appendix
+ Close the rear cover.
OR
+ Remove the worn ink ribbon from its housing.
+ Position the ink ribbon above its housing under the rear cover.
+ Insert the ink ribbon into its housing without removing the adhesive strip (2):
• Position the right-hand (white) end of the main roller onto the retractable axis.
• Position the left-hand (green) end of the main roller onto the left axis.
OR
+ Pull off the adhesive strip (2) from the ink ribbon.
OR
+ Insert the small roller into its housing:
+ Check that the gear axis (3) is correctly positioned in its slot (4) as is the other axis (5) in its corres-
ponding slot (6).
2
2
2
2
6
5
4
3
6
5
4
3
A