Operation Manual
27
Introduction
1
2
3
4
5
7
Options
Appendix
Telephoning
Directory
Settings
Fax
TAD
Printing
TAD (Menu 4)
6
Doc control
Advanced
functions
'HOHWLQJDVHOHFWHGPHVVDJH
Individually, while listening to it, you can delete a message that has not been totally listened to.
+ Press the C key, then OK during the message you want to delete.
6DWXUDWLRQRIWKH7$'·VPHPRU\
When too many faxes have been received and too many messages have been recorded, your machine is
saturated and cannot take in any other message: the message
MEMORY FULL is displayed. Print out the
faxes and/or delete the voice messages to get some spare memory.
5
You can interrogate your TAD remotely and thus listen to the messages you have received, only if the
telephone set you are calling from supports the tone dialling mode.
❑ As delivered, this option is not available: to interrogate your TAD remotely, you should first enter
a remote interrogation code, which is shared with the fax answering machine (so that you can
also print out the faxes received). Please refer to § Remote interrogation code on page 18, for
more information.
+ On a remote telephone set, dial your own number.
+ Press the * key during the greeting message, then enter the 4 digits of your interrogation code: the
machine delivers all the voice messages you have received.
+ After the last message or if there is no message, the machine emits a series of beeps.
List of available remote operations:
While listening:
• Pause or resume message listening by pressing .
• Go to the next message by pressing .
• Listen to the same message again by pressing .
• Go back to the previous message again by pressing . twice
After listening:
• Delete received messages by pressing then .
• Record your greeting message by pressing then and
stop the recording by pressing any key.
• Listen to your greeting message by pressing .
• Switch on your TAD by pressing .
• Switch off your TAD by pressing .
• Resume message listening by pressing .