Network Router User Manual

Appendix E - Default configuration
SAGEM F@st™ 1500 Reference Manual - 288053220-04
Reproduction and communication prohibited without the written permission of E
E E
E Page E-3
E.4 Default configuration on the wide area network side
WAN characteristics Function - Mode State/Value
ATM characteristics Protocol PPPoA
VPI 8
VCI 35
Encapsulation VC MUX
QoS Class UBR
PCR 4000 cells/s
SCR 4000 cells/s
MBS 10
NAT Enabled
Default route ADSL interface address
DNS relay Enabled
Firewall Enabled
Intrusion detection Disabled
OAM F4 and F5 (see Note) Enabled
Note: The OAM functions provided are as follows:
- Segment and end-to-end flow F4 and F5 management by VC.
- AIS/RDI functions.
- Response to loopback cells F4 or F5.
- Response to continuity check (CC) enable/disable cells.
PPP characteristics IP address Automatic negotiation
MTU 1400
Connect Type Always Connected
Remote Management Access Disabled
ADSL characteristics Maximum upstream rate 896 kbit/s
Maximum downstream rate 8160 kbit/s
Mode Multimode
Latency Simple latency (fast or interleaved)
Note: The user can revert to the default configuration via the HTTP interface.
E.5 Default configuration for advanced functions
Advanced functions
characteristics
Function - Mode State/Value
UPnP Enabled
DDNS Disabled