QIG 253500583A Fast 2704R_EN.book Page 1 Mardi, 21.
QIG 253500583A Fast 2704R_EN.book Page 2 Mardi, 21. août 2012 8:48 08 F@ST 2704R Sagemcom thanks you for choosing the F@ST 2704R series routers and hope that it will provide you with full satisfaction. F@ST 2704R products provide full ADSL functionality on POTS (ITU G.992.1/3/5 Appendix A) and on ISDN (ITU G.992.1/3/5 - Appendix B). F@ST 2704R routers include four ethernet interfaces (LAN1 to LAN4). Copyright © Sagemcom Broadband SAS All rights reserved. Sagemcom is a registered trademark.
QIG 253500583A Fast 2704R_EN.book Page 3 Mardi, 21.
QIG 253500583A Fast 2704R_EN.book Page 4 Mardi, 21. août 2012 8:48 08 F@ST 2704R Safety instructions Power supply source • Do not cover the router’s power adapter. • The router comes with its own power adapter. Do not use another adapter. • This class II adapter does not need to be grounded (earthed). The connection to the electrical network should comply with the indications given on the label. • Use a readily accessible AC power outlet located near the router. The power supply cord is 1.5 m long.
QIG 253500583A Fast 2704R_EN.book Page 5 Mardi, 21. août 2012 8:48 08 F@ST 2704R • Do not expose the router to splashes of water. • Avoid blocking any vent openings or exhaust exits on this equipment. Do not place equipment in a built-in installation such as a cabinet that may impede the flow of air through the ventilation openings. • Do not use the router or its peripherals for outdoor transmissions. Maintenance • This equipment is not user serviceable and is to be serviced by qualified personnel only.
QIG 253500583A Fast 2704R_EN.book Page 6 Mardi, 21. août 2012 8:48 08 F@ST 2704R For North America IMPORTANT SAFETY INSTRUCTIONS When using this equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following: • The equipment is for indoor use in dry locations. • Operate the equipment on maximum ambient temperature 40 °C, without any cover.
QIG 253500583A Fast 2704R_EN.book Page 7 Mardi, 21. août 2012 8:48 08 F@ST 2704R USA FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.
QIG 253500583A Fast 2704R_EN.book Page 8 Mardi, 21. août 2012 8:48 08 F@ST 2704R FCC Radiation Exposure Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
QIG 253500583A Fast 2704R_EN.book Page 9 Mardi, 21. août 2012 8:48 08 F@ST 2704R A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a compatible modular jack that is also compliant.
QIG 253500583A Fast 2704R_EN.book Page 10 Mardi, 21. août 2012 8:48 08 F@ST 2704R +1 (972) 674-4100, or Sagemcom USA, 14651 N. Dallas Parkway, Suite 900, Dallas, TX 75254. If the equipment is causing harm to the telephone network, the Telephone Company may request that you disconnect the equipment until the problem is resolved. Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation commission for information.
QIG 253500583A Fast 2704R_EN.book Page 11 Mardi, 21. août 2012 8:48 08 F@ST 2704R The Ringer Equivalence Number is an indication of the maximum number of devices allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices does not exceed five.
QIG 253500583A Fast 2704R_EN.book Page 12 Mardi, 21. août 2012 8:48 08 F@ST 2704R This Class B digital apparatus complies with Canadian ICES-003. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Cet appareil est conforme aux normes d'exemption de licence RSS d'Industry Canada. Son fonctionnement est soumis aux deux conditions suivantes : 1.
QIG 253500583A Fast 2704R_EN.book Page 13 Mardi, 21. août 2012 8:48 08 F@ST 2704R Connection Connecting your router Make the connections as shown in the diagram below. Line wall socket Phone set Filter/Spitter LINE PHONE Mains Adapter with its lead MODEM ETH1 ETH2 ETH3 ETH4 PWR Line cord LINE PWR Connecting additional telephones Make the connections as shown in this diagram.
QIG 253500583A Fast 2704R_EN.book Page 14 Mardi, 21. août 2012 8:48 08 F@ST 2704R Router supervision You can monitor the router’s activity and status using the following sources: • status of the LEDs on the front and left panels of the router, • using the router’s built-in "DSL Router" HTTP controller, available in the HTTP configuration tool, accessible at http://myrouter or http://192.168.1.1.
QIG 253500583A Fast 2704R_EN.book Page 15 Mardi, 21.
QIG 253500583A Fast 2704R_EN.book Page 16 Mardi, 21. août 2012 8:48 08 253500583-A - 08/12 All rights reserved. The information and specifications included are subject to change without prior notice. Sagemcom Broadband SAS tries to ensure that all information in this document is correct, but does not accept liability for error or omission. Non contractual document. All trademarks are registered by their respective owners.