User's Manual

Safety and Certifications
253584659-A 20 January 2014 2
Federal Communications Commission (FCC) Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Modifications:
You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
FCC Responsible Party: Sagemcom USA
14651 N. Dallas Parkway
Suite 900
Dallas, TX 75254
Phone: 972-674-4100
Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device produces radio frequency energy in the 2.4 GHz and 5 GHz spectrums. The antenna must be
positioned to keep a minimum distance of 20 cm (0.65 ft) from the radiating element to any nearby
person.
Issued by Sagemcom Broadband SAS
Sagemcom
250, route de l'Empereur - 92848 RUEIL MALMAISON CEDEX
FRANCE
© Sagemcom Broadband SAS 2013
All rights reserved. Subject to availability.
Rights of modifications reserved.
www.sagemcom.com
Safety and Certifications
253584659-A 20 January 2014 3
Wall Mounting Router (Optional)
While many users place their Fast 5260 series gateways on their desk, it can be optionally wall mounted.
1. The unit is wall mounted with the top of the unit facing up.
2. Ensure that the wall you use is smooth, flat, dry, and sturdy.
3. The unit is mounted using two M3x20 screws (20mm length and 3mm in diameter).
4. Install the two screws 135 mm (5.3 inches) apart approximately 20 mm (0.8 inches) below the
desired top of the unit per the following figure.
5. Screw the screws into the wall leaving their heads extending approximately 3.5 to 4.0 mm
(0.15 inch) from the wall surface.
6. Carefully align the screw heads in the keyholes on the back of the unit and gently push it onto the
wall moving it downward to secure it in the narrow portion of the keyhole slots.