User's Manual

Page 5/51
HiAll
NC
User Manual 2012/06/28
1 OVERVIEW
1.1 OBJECT OF THE DOCUMENT
The aim of this document is to provide technical guidelines to help the customer to design solutions based on
HiAll
NC
module.
1.2 REFERENCE DOCUMENTS
[1] URD1 5717.1 004 72589 - HiAll
NC
Technical Specification
[2] URD1 5635.1 008 70248 - AT Command Set for SAGEMCOM Modules
[3] URD1 5635.1 118 72618 – Radio Application Note for Hilo Modules
[4] URD1 5696 3 001 72497 - HiLo
NC
-3GPS Technical Specification
1.3 DOCUMENT MODIFICATIONS
The information presented in this document should be accurate and reliable. However Sagemcom assumes no
responsibility for its use, nor any infringement of patents or other third party rights which may result from its use.
This document is subject to change without notice.
1.4 CONVENTIONS
SIGNAL NAME: All signal names written on the pins of the HiAll
NC
module are in italics.

Specific attention must be granted to the information given here.
1.5 TERMS AND ABBREVIATION
ADC Analog to Digital Converter
CODEC Coder-Decoder
CLIP Calling Line Identification Presentation
COLP Connected Line Identification Presentation
CLIR Calling Line Identification Restriction
COLR Connected Line Identification Restriction
CTS Clear To Send
CSD Circuit Switched Data
CS Codec Scheme
DCS Digital Communications System
DSR Data Set Ready
DTR Data Terminal Ready
EDGE Enhanced Data Rate for GSM Evolution
EGSM Extended GSM
ENS Enhanced network selection
EONS Enhanced operator name string
ESD Electrostatic Discharge
ETS European Telecommunication Standard
FTA Full Type Approval
GLONASS GLObal NAvigation Satellite System
GNSS Global aeronautical Navigation Satellite System
GSM Global System for Mobile communication
GPRS General Packet Radio Services
GPS Global Positioning System