Operation Manual

English
- 14 -
4. Press and hold key for 5 seconds (after 1 minute if no Handset has started association
process the base goes back to standby).
5. Press menu key to confirm. The display shall show "WAITING" to indicate the waiting state.
6. Once the handset is registered, you will hear a confirmation tone. The handset automatically
exits the registering mode.
7. The handset number assigned automatically by the base appears on the screen.
9.3. Disassociation of a handset
This function allows you to de-register a handset from your base.
1. Press menu. Select "advanced set " using the or key, press menu.
2. Using the or key, select "unregister ". Press menu.
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_»
is replaced by a «*». Press menu key to confirm.
4. Select the handset you want to delete (at standby state, "pls reg h/s " is displayed on the
screen).You will hear a long beep confirmation tone.
9.4. Modifying the country
1. Press menu. Select "advanced set " using the or key, press menu.
2. Using the or key, select "country ". Press menu.
3. Enter the 4 digit base master PIN code (default 0000). Each time a digit is entered the «_»
is replaced by a «*». Press menu key to confirm.
4. Using the or key, select the country where you will use the telephone. Press menu.
5. A confirmation screen appears, press menu.
The message "waiting " appears on the screen. You will hear a confirmation tone.
9.5. Restoring the Handset / Base Default Settings
To restore the factory settings for your Handset or your Base:
1. Press menu. Select "advanced set " using the or key, press menu.
2. Using the or key, select "reset ". Press menu.
3. A confirmation screen appears, press menu.
- If you want to confirm the reset, press menu.
- To cancel the reset, press
.
4. You will hear a confirmation tone : the settings of your phone are restored to their initial
values.
9.6. Prefix (Depending on Country)
If a PABX is used in a private network, you can program the outside call prefix.
This function sets:
- The PABX prefix number: this number will be added at the beginning of the number you
dialled.
- The number to be detected: if the number you dialled starts with the recorded sequence, this
sequence will be automatically deleted.
These two settings are not applied if number you dialled starts with "#" or "*".
1. Press menu. Select "advanced set " using the or key, press menu.
2. Using the or key, select "auto prefix ". Press menu.
3. Select "detect digit " to define the number giving you access to the outside line.
4. Select "prefix " to specify the «digits before prefix».
5. Press menu key to confirm your selection. You will hear a confirmation tone.