Operation Manual

SWITCHING ON

CHOOSING THE ADAPTOR

Choose the adaptor according to your country.

1. Assemble the adaptor into the power transformer supplied.

SWITCHING ON YOUR RADIO

1. Connect the power transformer supplied with your radio.

2. Connect the power plug to the mains.

For the model HM40, the icon indicates that your radio is

charging. The charge cycle is complete when the icon is full.

USING THE RADIO DAILY

LOCKING / UNLOCKING THE RADIO

To carry your radio while it is on, place the button on the right side of your radio in the raised

position. The control buttons are inactive.

POSITIONING THE FM/DAB AERIAL

For optimal reception, extend the aerial. If necessary, move it to adjust the position.

SWITCHING FROM FM MODE TO DAB MODE

Press the key on the right side of your radio.

The screen displays the corresponding icon.

SEARCHING FOR A RADIO STATION

IN FM MODE

1. Press the key. The station search screen appears.

2. Turn the knob to the right or left to scan the FM band.

The progression is displayed on the screen.

3. At the end of the search, the radio broadcasts the station with the best signal.

Only use batteries, chargers and accessories approved for use with this model.

Connecting other accessories may be dangerous and void your warranty rights.

Before using your radio the first time, change it for 12 hours.

The battery will operate best after 3 to 4 charge cycles. As batteries have a limited

lifespan, standby or operating autonomy will diminish with use.

Keep the aerial away from any source of radiation to prevent interference (television,

video recorder, etc.).

The message No signal - Start over is displayed if the reception quality is insufficient

in DAB mode. Check the direction of the aerial.

To fine tune your scan, you can manually scan the FM band. For more details, see the

section “Choosing the FM station search mode”, page 10.

LU_HL40_HM40_EN.book Page 7 Lundi, 9. mai 2011 9:17 09