Operation Manual

RTI90-320/500 T2 HD UK

Setting network

This feature allows you to define your network

parameters:

1. Go to Receiver settings > Network settings.

2. Define your Ethernet configuration:

•Manual: in this case, enter the figures of each

address required, or

•DHCP configuration.

Resetting the receiver

1. Go to Receiver settings > Reset factory default.

2. Enter your parental code and press the key.

A warning message appears.

3. To cancel the operation, press the or key.

To confirm the reset, press the [Confirm] key.

Once the default settings are restored, the receiver

installation screen is displayed. You can then

reconfigure your receiver (see section Running your

first installation, page 22).

Note

If you reset the default settings, you lose the channels and settings you made.

This operation does not erase the recordings saved in the recording list.

LU 253335051-B RTI90-320_500 T2 HD UK.book Page 50 Jeudi, 13. octobre 2011 2:50 14