Instructions / Assembly

Switch Housing
Screws
Thumbscrews
Blue Wires
White Wires
Bulb
Light Kit
Globe
Fan with light kit
8
Glass Installation Options 1
Figure 13
Figure 14
1. Connect the two blue to blue light kit wires by
single pin and connect the two white to white
light kit wires by single pin.
2. Remove the three screws from the switch
housing, then insert the light kit into the
switch housing.
3. Align the three screw holes in the switch
housing with the screw holes in the light kit.
4. Re-Install the three screws.
5. Install bulb provided.
6. Insert the globe into the xture. Tighten the
thumbscrews manually until nger-tight. Do
not overtighten.
Note: If thumbscrews are pre-installed, loosen
the thumbscrews before inserting the globe,
then retighten securely.
Your Fan will have one of the following 3 light
kit options: Globe, Bowl, or Multi-Arm Light
Kit.
Option 1
Attaching the Globe
1. Only the fan pull chain is functional. Second
light pull chain in switch housing does not
function for this conguration but must
be in the “on” position for proper light kit
operation.
2. Refer to the instructions that came with your
accessory light kit for proper assembly.
3. Consult a certied electrician if needed.
Aftermarket Option
Accessory Light Kit
for fans without light kits
80009 ∙ 06/23/11 ∙ PCI