Instructions / Assembly

Screws
Light kit
Reverse
Switch
4 Pin Connector
(or 4 pin connector)
Switch Housing
Thumb
Screws
Bulbs
Glass Shade
NOTE
YOUR FAN MAY HAVE A 4 PIN CONNECTOR THAT
WILL BE USED IN PLACE OF THE WHITE AND
BLUE WIRE CONNECTORS
! !
CAUTION
BEFORE STARTING INSTALLATION,
DISCONNECT THE POWER BY TURNING OFF
THE CIRCUIT BREAKER OR REMOVING THE
FUSE AT FUSE BOX. TURNING POWER OFF
USING THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
NOTE
THE LIGHT KIT WITH YOUR FAN MAY HAVE 3
OR 4 LIGHTS
10
Glass Installation Options 3
Figure 17
Figure 18
Option 3
Installing the
Multi Arm Light Kit
1. While holding the light kit assembly under
your fan, locate two single white and blue
wires in the switch housing labeled FOR
LIGHT. Make the polarized plug connections:
- White to white
- Blue to black
2. Carefully push all wires back into the switch
housing. Attach the light kit tter by aligning
its keyhole slots with the three screw holes
and the reverse switch on the side of the
switch housing. Tighten the three screws
securely to prevent the light kit from vibrating
loose. (Fig. 17)
3. Mount the glass shades to the light xture
by unscrewing partway the thumbscrews on
the glass holders, insert the glass, then gently
tighten the thumbscrews by hand evenly to
the glass. DO NOT OVER TIGHTEN
(Fig. 18).
4. Install three bulbs (included). NOTE: CFL
bulbs are NOT dimmable.
80009 ∙ 06/23/11 ∙ PCI