Instructions / Assembly

Screws
Pull Chains
Switch Housing
Bulbs
Glass
Shade
(Bowl)
Glass Cap
Decorative Nut
Metal Washer
Rubber Washer
Hex Nut
Wire Connectors
Light Kit
Assembly
Metal Stem
Switch Housing
Screws
Switch Housing
Cover
NOTE
NOTE
BEFORE STARTING INSTALLATION,
DISCONNECT THE POWER BY TURNING OFF
THE CIRCUIT BREAKER OR REMOVING THE
FUSE AT FUSE BOX. TURNING POWER OFF
USING THE FAN SWITCH IS NOT SUFFICIENT TO
PREVENT ELECTRIC SHOCK.
MAKE SURE TO LEAVE ENOUGH SPACE
BETWEEN THE FAN PULL CHAIN AND THE
BULBS SO THE CHAIN DOESN’T RUB AGAINST
ANY OF THE BULBS.
NOTE
LIGHT BULBS HAVE NO WARRANTY; CAN BE
PURCHASED AT ANY HOME RETAILER.
NOTE
YOUR FAN MAY HAVE A 4 PIN CONNECTOR THAT
WILL BE USED IN PLACE OF THE WHITE AND
BLUE WIRE CONNECTORS.
10
Glass Installation Options 2
Option 2
Installing the
Bowl Light Kit
1. Unscrew the hex nut from the top of the light
socket and insert light socket through the hole
in the bottom center of the switch housing, then
reassemble the hex nut to the light socket securing
the two pieces rmly together.
2. While holding the light kit assembly under your
fan, locate two single white and blue wires in the
switch housing labeled FOR LIGHT. Make the
polarized plug connections:
- White to white
- Blue to black
3. Carefully push all wires back into the switch
housing. Attach the light kit tter by aligning its
keyhole slots with the three screws holes and
reversing switch on the side of switch housing.
Tighten the three screws securely to prevent the
light kit from vibrating loose. (Fig. 20)
Your fan is designed with light kit, in case you
intend to install the fan without light kit, attach
the switch housing cover to the switch housing
with the screws provided. (Fig. 21)
Fan without Bowl Light Kit
(Optional)
4. Install bulbs (included).
5. Place the glass shade over the light kit stem. While
holding the shade in place, position the glass cap
over the threaded stem and secure entire assembly
with the decorative nut. Do not overtighten.
6. Feed the pull chain(s) through the eyelet in the
shade and cap. Secure the light kit assembly with
decorative nut provided. Do not overtighten.
(Fig. 20)
Figure 20
Figure 21
8002 ∙ 06/23/11 ∙ PCI