Instructions / Assembly

SUPPLY CIRCUIT
BLACK WHITE
BLACK
BLUE
GREEN
WHITE
Ground
Conductor
Outlet Box
Green
Ground
Lead
Ground to
Downrod
Switch
Canopy
Motor Housing
! !
WARNING
! !
WARNING
ELECTRICAL DIAGRAMS ARE FOR REFERENCE
ONLY. OPTIONAL USE OF ANY LIGHT KIT SHALL
BE UL LISTED AND MARKED SUITABLE FOR USE
WITH THIS FAN.
CHECK TO SEE THAT ALL CONNECTIONS ARE
TIGHT, INCLUDING GROUND, AND THAT NO
BARE WIRE IS VISIBLE AT THE WIRE NUTS,
EXCEPT FOR THE GROUND WIRE.
! !
WARNING
TO REDUCE THE RISK OF SHOCK, INSURE
ELECTRICITY HAS BEEN TURNED OFF AT THE
CIRCUIT BREAKER OR FUSE BOX BEFORE
BEGINNING.
7
Making e Electrical Connection
Figure 15
If you feel you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
Follow the steps below to connect the fan to
your household wiring. Use the wire connecting
nuts supplied with your fan. Secure the
connectors with electrical tape. Make sure there
are no loose strands or connections.
1. Connect the ground conductor of the 120v
supply (this may be a bare wire or a wire
with green colored insulation) to the green
ground lead(s) of the fan (Figure 15). When
using standard ceiling mounting, there are
two green grounding leads; one from the
ceiling mounting bracket and one from
the ball/downrod assembly. When using
“closeto-ceiling” mounting, there is only one
green ground lead from the ceiling mounting
bracket since the ball/downrod assembly is
not used.
2. Connect the fan motor white wire to the
supply white (neutral) wire using a wire nut
(Figure 15).
3. Connect the fan motor black wire to the
supply black (hot) wire using a wire nut
(Figure 15).
4. Connect the blue wire for the light kit to the
black household supply wire.
5. Turn wire nut connections upwards, spreading
them apart so the green (grounded) wire will
be on one side of the outlet box and the white,
black, and blue wires will be on the other
side, and push carefully up into the outlet box.
8002 ∙ 06/23/11 ∙ PCI