Use and Care Manual

OPERATION INSTRUCTIONS
1. Carefully remove the heater from the carton and bag. Make certain the unit is in
the OFF position before plugging the heater into the power outlet.
2. Before using the heater, make sure that it is on a flat and stable surface.
Damage may occur if it is placed in an incline or decline.
3. Turn the power control to the off position and then plug the heater power cord
directly into a standard AC outlet. The outlet may need to be replaced if the
plugs fits loosely when inserted into the outlet.
4. When the heater is not in use, turn all the controls to OFF（O）, and remove plug
from the socket-outlet.
NOTE: When the heater is turned on you may notice vibration/noise coming from
the grill and the interior quartz tubes. PLEASE NOTE THAT THIS IS NORMAL
AND SAFE OPERATION. Once the quartz heating element has warmed up, the
vibration/noise will go away.
NOTE: THIS UNIT IS FOR FLOOR USE ONLY.
Power Control
Turn the Power Control to the desired setting:
I/O - off Mode
If you want to shut off the heater at any time of operation, turn the Power Control to
Off (I/O) position. Power Light may remain lit until the heater is unplugged.
"1" – Low Heat Setting (750 Watts)
"2" – High Heat Setting (1500 Watts)
Thermostat Control
1. Before setting the thermostat, allow heater to operate and heat the room. As
noted above, turn the Thermostat Control clockwise to highest setting to
start the heater.
2. When the desired temperature is reached, turn the thermostat control
counter clockwise until the heater turns off.
3. The control will now automatically maintain the pre-set temperature level by
turning the heater ON and OFF.
NOTE: It is normal for the heater to cycle ON and OFF as it maintains the preset
temperature. To prevent the unit from cycling, increase the thermostat setting.
CAUTION: FRONT GRILL IS HOT WHEN UNIT IS IN OPERATION.