Specifications

24
Section 7: Retract Servo Installation
Step 11
With the retract servo in the retracted position, push the
retract linkage to manually retract the landing gear. Install
a 4-40 x 1/4" screw into the easy connector and tighten it
to secure the retract linkage.
Step 12
Cycle the retract system several times to make sure there
is no binding. Also check to verify the gear locks in
both the extended and retracted positions. Make any
necessary adjustments to be sure the retracts are
working and locking correctly.
Section 8: Main Landing Gear and
Wheel Doors
Required Parts
• Wing assembly • Landing gear door (2)
• Wheel collars (4) • M3 x 8 screw (4)
• Axle mounts (2) • Axles (2)
• 6-32 set screw (2) • 8-32 set screw (2)
• #4 x 7/16" screws (8)
• Main landing gear wheels (2)
• Landing gear door mounts (2)
Required Tools
• Felt-tipped pen • Phillips screwdriver
• Drill Bit: 1/8" • Drill
• Moto-tool w/cut-off wheel
• Threadlocking compound
Step 1
Slide the two landing gear door mounts onto the
landing gear strut. The position of the mounts will
be determined later.
Step 13
Repeat Steps 1 through 12 for the remaining retract.
Photo for Step 12
Photo for Step 12