Specifications

Section 11: Lower Air Intake Installation
33
Step 5
Position the air scoop onto the wing bolt plates. It
should fit snug onto the plates. Remove the air scoop,
and apply a thin bead of medium CA around the bottom
edge of the air scoop. Place it back into position and
allow the CA to cure before proceeding.
Step 6
Remove the wing from the fuselage.Try to keep the wing
bolts in the wing. Once the wing is removed, slide the
plastic guide tubes through the scoop and over the heads
of the wing bolts. The ends of the tubes will lock into the
plywood tube locators when fully installed.
Step 7
Remove the wing bolts from the plane by sliding them out
through the tubes. Remove the tubes and roughen them
using medium sandpaper.
Step 8
Apply a thin bead of thick CA around one end of the
tubes. Slide the tube in position through the air scoop
and into the plywood tube locators. Use a paper towel
to clean up any excess CA from the air scoop.