Specifications

Section 15: Tail Wheel Installation
39
Required Parts
• Pushrod wire (33-5/8" long)
• Nylon clevis • Clevis keeper
• Wheel collar (2) • M3 x 8 screw
• #2 x 3/8" screw (4) • Tail wheel
• Wire tail gear • Tail gear steering arm
• Tail wheel
Required Tools and Adhesives
• Pliers • 1.5mm hex wrench
• Drill Bit: #20 • Drill
• File • Side cutters
• Threadlocking compound
Step 1
Locate the tail wheel. Carefully drill the hole for the
axle using a #20 drill.
Step 2
File a flat spot on the tail gear wire. Position the flat
off-center slightly as shown in the photo.
Step 3
Install the 33
5
/
8
" pushrod wire into the pushrod tube
shown. Make sure the threaded end is installed first,
leaving the non-threaded end inside the radio area.
Hint: Install the pushrod wire through the hole
in the firewall to avoid bending the wire.