Specifications

Section 17A: Engine Installation (Saito 180GK)
45
Step 3
Prepare the engine mount for installation by sliding
four 8-32 bolts and washers through the engine
mount. Position the plywood engine mount spacers
onto the bolts as shown.
Step 4
Install the engine mount.
Step 5
Install the spinner back plate and propeller. Position the
engine so there is between 1/16" and 1/8" gap between
the back plate and fuselage.
Step 6
Remove the spinner back plate and tighten the screws
holding the engine to the mount. An 11/32" socket
wrench will make this task a lot easier.