Specifications

52
Section 19: Radio Installation
Step 5
Connect any necessary extensions and Y-harnesses
necessary to connect up the retract, aileron and flap
servos. Connect the elevator, rudder and throttle
servo leads to the receiver.
Step 6
Wrap the receiver in protective foam to prevent damage
that may be cause by engine vibration.
Step 7
Wrap the receiver battery in protective foam as you did
the receiver. Temporarily mount the receiver and battery
into the fuselage. It may be necessary to relocate the
battery forward or aft to balance the model as described
in the section “Control Throws and Center of Gravity.”
Step 8
Route the antenna out through the bottom of the fuselage
and secure it to the tail wheel with rubber bands.