Specifications

Section 20: Rudder and Elevator Linkages
55
Step 11
Slide the wire through the outer hole in the elevator servo
arm. Secure the wire using a nylon wire keeper.
Step 12
Repeat Steps 3 through 11 for the remaining elevator half.
Step 13
Center the rudder servo electronically using the radio
system. Install a servo arm onto the rudder servo.
Physically place the tail wheel in neutral. Mark the
pushrod where it crosses the holes in the servo arm.
Step 14
Bend the wire 90 degrees at the mark made in
the previous step.
Step 15
Cut the wire 1/2" above the bend.
Step 16
Slide the wire through the inner hole in the rudder servo
arm. Secure the wire using a nylon wire keeper.
Step 9
Bend the wire 90 degrees at the mark made in
the previous step
Step 10
Cut the wire 1/2" above the bend.
Photo for Step 8