Specifications

Section 21: Throttle Linkage Installation
57
Required Parts
• Easy connector • M3 x 8 screw
• Connector back plate
Required Tools and Adhesives
• Phillips screwdriver • Pliers
• Drill Bit: 3/32" • Drill
Step 1
Use a 3/32" drill bit to drill out the holes in a servo
arm. Attach an easy connector to the arm using a
connector back plate.
Step 2
Center the throttle stick and trim with both the receiver
and transmitter on. Slide the easy connector onto the
throttle pushrod. Install the throttle servo arm in the
neutral position as shown.
Step 3
Move the throttle stick and trim to low. Check to make
sure the carburetor will move to the low position when
operating the servo. Install an M3 x 8 screw to secure
the easy connector to the throttle pushrod. Check the
movement of the throttle to verify there is no binding at
either low or high throttle. If there is, make the necessary
adjustment to eliminate any binding. Install the throttle
servo arm screw when complete.
Step 4
Use scrap wood to make a brace for the throttle pushrod
tube near the servo as shown.