Specifications

Section 1: Hinging the Ailerons
7
Step 5
Turn the wing panel over, deflect the aileron in the
opposite direction and apply thin CA to the other side
of the hinges as described in the previous step. Make
sure the thin CA penetrates completely into both the
aileron and wing panel.
Step 6
Use CA remover/debonder and a paper towel to remove
any excess CA accumulated on the wing or aileron
surface. Allow time for the CA to completely cure
before moving to the next step.
Step 7
Firmly grasp the wing and aileron and gently pull on
the aileron to ensure the hinges are secure and cannot
be pulled apart. Use caution when gripping the wing
and aileron to avoid crushing the structure.
Step 8
Work the aileron up and down several times to work in
the hinges and check for proper movement.
Step 9
Repeat Steps 1 through 8 for the remaining aileron.