Specification

ManualsBrandsSAKRETE ManualsBuilding materials80 lb. White Stucco Finish Coat

MATERIAL SAFETY DATA SHEET

Revision Date: 12/22/2006 1

SECTION I - PRODUCT AND COMPANY IDENTIFICATION

Identity: SAKRETE® TYPE S MASONARY MORTAR, 60# & 80#

SAKRETE® FINISH COAT STUCCO WHITE/GREY, 80#

SAKRETE® SCRATCH AND BROWN COAT STUCCO, 80#

SAKRETE® FIBERED ONE COAT STUCCO SANDED, 80#

Manufacturer's Name & Emergency Telephone Numbers:

BASALITE Concrete Products, LLC

605 Industrial Way 11888 West Linne Road 2600 Boeing Way

Dixon, CA 95620 Tracy, CA 95376 Carson City, NV 89701

(707) 678-1901 (209) 833-3670 (775) 882-9336

MSDS Information Telephone Number: (916) 631-6574

SECTION II - PRDOUCT AND COMPONENT DATA

Composition CAS Number

Cement 65997-15-1

Mortar Sand Mixture

Lime Mixture

Other Ingredients: Small traces of Non-Hazardous ingredients are present in the following mixes:

FIBER - Fibered One Coat Stucco Sanded, and Scratch and Brown Coat Stucco

FIRE CLAY - Finish Coat Stucco, White or Grey

EXPOSURE LIMITS:

Composition CAS Number ACGIH TLV OSHA PEL IDLH

*Crystalline Silica (Quartz) 14808-60-7 *See Below *See Below 5000 mg/m

**Cement 65997-15-1 10 mg/m

(tot.) 15 mg/m

(tot.)

5 mg/m

(resp.) 5 mg/m

(resp.)

OSHA PEL for crystalline silica in the form of quartz is = 10 mg/m

÷ (% SiO

+2) , and 50% of this value for crystobalite

and tridymite.

** Portland cements are listed by OSHA in 29 CFR 1010.1000, Table Z-1-A and require material safety data sheets (FR,

January 19, 1989). MSHA (30 CFR 55.5.-1, Ref. 2), ACGIH (TLV’s for 1973, Appendix E) and ACGIH (TLV’s for 1984-5,

Appendix D) list Portland cements as nuisance dusts. Portland cements are

NOT listed by NTP, IARC, or OSHA as

carcinogens. However, since Portland cement is manufactured from raw material mined from the earth (limestone, marl,

sand, shale, clay, etc.) and process heat is provided by burning fossil fuels, trace, but detectable, amounts of naturally

occurring, and possible harmful, elements may be found during chemical analysis. Under ASTM standards, Portland

cement may contain .75 percent insoluble residue. A fraction of these residues may be free crystalline silica.

SECTION III - HEALTH HAZARD and FIRST AID INFORMATION

Summary of content (4 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET SECTION I - PRODUCT AND COMPANY IDENTIFICATION Identity: SAKRETE® TYPE S MASONARY MORTAR, 60# & 80# SAKRETE® FINISH COAT STUCCO WHITE/GREY, 80# SAKRETE® SCRATCH AND BROWN COAT STUCCO, 80# SAKRETE® FIBERED ONE COAT STUCCO SANDED, 80# Manufacturer's Name & Emergency Telephone Numbers: BASALITE Concrete Products, LLC 605 Industrial Way Dixon, CA 95620 (707) 678-1901 11888 West Linne Road Tracy, CA 95376 (209) 833-3670 MSDS Information Telephone Number: 2600 Boeing Way Carson Cit
PAGE 2
CHRONIC HAZARDS: Primary Route of Exposure: Inhalation Exposure Limits: (Acceptable exposure levels for this product must be defined in the workplace due to the combination of silica and other constituents and condition of use.) Unless specified otherwise, limits are expressed as eight-hour Time-weighted averages (TWA). Limits for cristobalite and tridymite (other forms of cyrstalline silica) are equal to one-half of the limits for quartz.
PAGE 3
Ingestion: Expected to be practically non-toxic. Ingestion of large amounts may cause gastrointestinal irritation and blockage. Inhalation: Dusts may irritate the nose, throat, and respiratory tract by mechanical abrasion. Coughing, sneezing, and shortness of breath may occur following exposures in excess of appropriate exposure limits. Use of natural sand and gravel for construction purposes is not believed to cause additional acute toxic effects.
PAGE 4
(visible) dusty conditions are present or are anticipated. LOCAL EXHAUST: When using mortar mix or stucco, use sufficient local exhaust to reduce the level of respirable dust to the applicable standards set forth in Section III. See ACGIH “Industrial Ventilation, A Manual of Recommended Practice,” latest edition. SAFETY MEASURES: Wear hard hats and/or steel-toed safety shoes if bags may fall from an elevation or be dropped during handling. WORK/HYGIENIC PRACTICES: Avoid creating and breathing dust.