Installation Guide

The Pro’s Choice Since 1936
sakrete.com • 866-725-7383
Sakrete Natural Concrete Paver Sealer is a specially formulated 100% acrylic
waterproofing sealer that provides excellent protection from moisture penetra-
tion and the effects of weathering on a variety of properly prepared substrates.
It requires no special solvents, is non-toxic to humans, animals, and vegetation.
FEATURES:
• Protectspaversfrom,oilandgreasestains
• Enhancesappearance
• Safeforplantsandpets
• Noncorrosive
• Driesfast
• ExcellentwearandUVresistance
• Easytoapply
• Resistsyellowing
•Sealsandresistsmoisturepenetration
•Environmentallyfriendly
USE FOR:
• Masonry/Stucco
• Cinderblock
• Porousconcretefloors
• Brickpavers
• Decorativestone
• Glassblockmortarjoints
• Interiororexterior
• Pre-castconcrete&tiltupconcrete
YIELD/WATER/COVERAGE:
NOTE:Yieldsareapproximate.Theyieldabovedoesnotallowforwasteand
spillage.
TEChnICAL DATA:
DIVISION7
WaterRepellent&Sealant–071900
DIVISION9
CoatingforConcrete&Masonry–099800
LEED ELIGIbILITY:
-RegionalMaterials(MR-c5)
COLOR:
Clear
PREPARATIOn:
For best results all materials should be stored between 40
0
F(4
0
C)and80
0
F
(27
0
C)24hourspriortoinstallation.
Referto:
- ACI530.1SpecificationforMasonryStructures
- InternationalMasonryIndustryAll-WeatherCouncil(IMIAC)
  •RecommendedPracticesandGuildSpecificationsforColdWeather
  MasonryConstruction
  •RecommendedPracticesandGuideSpecificationsforHotWeather
  MasonryConstruction
NOTE:itistheresponsibilityoftheinstaller/applicatortoensurethesuitabilityof
the product for its intended use.
1. Useonlywhentheproduct,air,andsurfacetemperatureareabove50
0
F
 (10
0
C)foraminimumof24hours.
2. Surfacestobecoatedmustbeclean,dry,sound,freefromalldirt,grease,
oils, waxes, curing agents and any other foreign materials that will inhibit
performance.
3. Moldormildewmustbeproperlytreatedandremoved.
4. Smooth concrete floors should be properly etched to effectively open
surface pores
5. Removeanyloose,crackedorpeelingpaintbysanding,scraping,wire
brushing, or by power tool cleaning methods.
6. Sandallroughpaintedgessmoothtoadjacentsurfacearea.Dullallglossy
surfaces.
7. Repairalldamaged,deterioratedorsurfaceimperfectionswiththeproper
patch or building materials.
Referto:
1. ASTMD4258StandardPracticeforSurfaceCleaningforCoating
2. ASTMD4259StandardPracticeforAbradingConcrete
MIXInG/ThInnInG:
1. Stir thoroughly and apply as it comes from the container. Thinning is not
 necessary.However,ifthinningisrequired,youmayaddcleanwaterup1/2
pint per gallon.
APPLICATIOn:
1. Apply by brush, roller cover or approved low-pressure hand pump sprayer.
2. Stirthoroughlybeforeandduringapplication.Forbestresults,applytwo
 (2)coats.
3. Useaqualitybrushtopaintsmallersurfaceareasandtocut-inwalls,edges
and corners.
4. Useaqualityrollercovertopaintlargersurfaceareas,suchaswalls,
 ceilings,etc.Maintainawetedgeapplyingwhenapplyingbybrushorroller.
Concrete Paver Sealer - Wet
bottle Size Yield/Coverage
1gallon(3.9L) 75-325sqftdependingonapplicationand
surface porosity